Rechercher une page de manuel

Chercher une autre page de manuel:

if_xe.4freebsd

Langue: en

Version: 300405 (debian - 07/07/09)

Section: 4 (Pilotes et protocoles réseau)


BSD mandoc

NAME

xe - Xircom PCMCIA Ethernet device driver

SYNOPSIS

To compile this driver into the kernel, place the following line in your kernel configuration file:
device xe

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:

 if_xe_load="YES"
 

DESCRIPTION

The driver supports PCMCIA Ethernet adapters based on Xircom CE2- and CE3-class hardware. This includes devices made by Xircom along with various OEM manufacturers.

Please note that the driver only supports PCMCIA cards and their Ethernet functions. does not support the on-board modem device located on some version of the Ethernet/modem combo cards. In particular, Xircom RealPort2 cards are not supported by this driver.

The driver supports the following media types:

autoselect
Enable autoselection of media type and options.
10Base2/BNC
Select 10Mbps operation on a BNC coaxial connector.
10BaseT/UTP
Select 10Mbps operation on a RJ-45 connector.
100BaseTX
Select 100Mbps operation.

Note that 100BaseTX operation is not available on CE2-class cards, while the 10Base2/BNC mode is only available on CE2-class cards. Full-duplex operation is currently not supported. For more information on configuring network interface devices, see ifconfig(8).

HARDWARE

The driver supports the following cards:

Other similar devices using the same hardware may also be supported.

DIAGNOSTICS

"xe%d: Cannot allocate ioport"
"xe%d: Cannot allocate irq"
A fatal initialization error occurred while attempting to allocate system resources for the card.
"xe%d: Unable to fix your %s combo card"
A fatal initialization error occurred while attempting to attach an Ethernet/modem combo card.
"xe%d: watchdog timeout: resetting card"
The card failed to generate an interrupt acknowledging a transmitted packet. May indicate a PCMCIA configuration problem.
"xe%d: no carrier"
The card has lost all contact with the network; this usually indicates a cable problem.

SEE ALSO

pccard(4), ifconfig(8)

HISTORY

The driver first appeared in Fx 3.3 .

AUTHORS

An -nosplit The device driver was written by An Scott Mitchell Aq rsm@FreeBSD.org . This manual page was written by An Scott Mitchell Aq rsm@FreeBSD.org , and An Tom Rhodes Aq trhodes@FreeBSD.org .

BUGS

Supported devices will fail to attach on some machines using the NEWCARD PC Card framework.

Automatic media selection is usually unreliable.

Je suis content de ma bagnole. Peut-on appeler ça de
l'auto-satisfaction ?
-+- Philippe Geluck, Le chat -+-