Rechercher une page de manuel

Chercher une autre page de manuel:

ips.4freebsd

Langue: en

Version: 300233 (debian - 07/07/09)

Section: 4 (Pilotes et protocoles réseau)


BSD mandoc

NAME

ips - IBM/Adaptec ServeRAID controller driver

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file:
device pci device scbus device ips

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:

 ips_load="YES"
 

DESCRIPTION

The driver claims to support the IBM (now Adaptec) ServeRAID series SCSI controller cards.

These cards come with a built in configuration utility stored in the firmware known as the ISPR This utility is accessed with the Aq Em Ctrl+I key combination during the initial card POST

It is highly recommended that this utility be used to configure the card before attempting to diagnose the below error messages.

In some cases, the driver can have difficulties attaching during the system initialization period. To avoid these difficulties, set the hw.ips.0.disable tunable to 1. It will prevent the driver from attaching.

HARDWARE

Controllers supported by the driver include:

DIAGNOSTICS

Several error codes may be shown when the card initializes the IBM ISPR utility and are independent of Fx .
ips%d: failed to get adapter configuration data from device
ips%d: failed to get drive configuration data from device

Unable to obtain adapter or drive configuration.

ips%d iobuf error

A buffer input/output error has occurred. Bq Er ENXIO

General adapter errors:

Attaching bus failed

This message is undocumented.

WARNING: command timeout. Adapter is in toaster mode, resetting

A command timeout has caused the adapter to be reset.

AIEE! adapter reset failed, giving up and going home! Have a nice day

An error occurred while attempting to reset the adapter.

unable to get adapter configuration
unable to get drive configuration

There was an error when attempting to get configuration information.

Adapter error during initialization.
adapter initialization failed

There was an error while attempting to initialize the adapter.

adapter failed config check
adapter clear failed

There was an error while checking the adapter.

device is disabled

The adapter is disabled.

resource allocation failed
irq allocation failed
irq setup failed

The driver was unable to allocate resources for the device.

Error messages due to DMA:

can't alloc command dma tag
can't alloc SG dma tag
can't alloc dma tag for statue queue
dmamap failed

Failure to map or allocate DMA resources.

Cache, buffer, and command errors:

failed to initialize command buffers
no mem for command slots!

The driver will return Bq Er ENOMEM in such cases.

ERROR: unable to get a command! can't flush cache!
ERROR: cache flush command failed!
ERROR: unable to get a command! can't update nvram
ERROR: nvram update command failed!
ERROR: unable to get a command! can't sync cache!
ERROR: cache sync command failed!
ERROR: unable to get a command! can't sync cache!
ERROR: etable command failed!

COMPATIBILITY

Unlike many of the other SCSI devices in Fx , the driver does not use the cam(4) SCSI subsystem.

SEE ALSO

ch(4), da(4), sysctl(8)

AUTHORS

The driver was written by An -nosplit An David Jefferys and An Scott Long Aq scottl@FreeBSD.org .

This manual page was written by An Tom Rhodes Aq trhodes@FreeBSD.org .

Ici, l'exemple est un peu capillotracté.
Si on choisissait plutôt un dilemme entre fr.comp.os.unix et
fr.rec.arts.os.unix ?
-+- APM in: Guide du Cabaliste Usenet - La Cabale est-elle barbue ? -+-