Rechercher une page de manuel

Chercher une autre page de manuel:


Langue: en

Version: 361738 (ubuntu - 24/10/10)

Section: 4 (Pilotes et protocoles réseau)

BSD mandoc


ixgbe - Intel(R) 10Gb Ethernet driver for the FreeBSD operating system


To compile this driver into the kernel, place the following line in your kernel configuration file:
device ixgbe

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:



The driver provides support for PCI 10Gb Ethernet adapters based on the Intel 82598EB Intel(R) Network Connections. The driver supports Jumbo Frames, MSIX, TSO, and RSS.

For questions related to hardware requirements, refer to the documentation supplied with your Intel 10GbE adapter. All hardware requirements listed apply to use with Fx .

Support for Jumbo Frames is provided via the interface MTU setting. Selecting an MTU larger than 1500 bytes with the ifconfig(8) utility configures the adapter to receive and transmit Jumbo Frames. The maximum MTU size for Jumbo Frames is 16114.

This driver version supports VLANs. For information on enabling VLANs, see ifconfig(8).


The driver supports the following cards:


"ixgbe%d: Unable to allocate bus resource: memory"
A fatal initialization error has occurred.
"ixgbe%d: Unable to allocate bus resource: interrupt"
A fatal initialization error has occurred.
"ixgbe%d: watchdog timeout -- resetting"
The device has stopped responding to the network, or there is a problem with the network connection (cable).


For general information and support, go to the Intel support website at:

If an issue is identified with the released source code on the supported kernel with a supported adapter, email the specific information related to the issue to Aq .


arp(4), netintro(4), ng_ether4, polling(4), vlan(4), ifconfig(8)


The device driver first appeared in Fx 7.0 .


The driver was written by An Intel Corporation Aq .
23:25 L'admin système de ma boîte il a mis le swap sur 2 bandes DAT en
RAID 0. Comme ça il n'y a pas de limite de taille et avec le RAID
c'est plus rapide que sans.
23:32 23:25 Il est con ton admin ? Pour le prix des lecteurs DAT il
aurait pu s'acheter au moins 200 Go de disques durs !!!
23:40 23:32 N'importe quoi !!! Et comment tu fait pour archiver le swap
avec des disques durs !!!!! Avec le lecteurs DAT il suffit de
changer les cassettes !!!! VA te coucher, pauv tache !
23:41 23:40 on peut savoir a quoi ca te sert d'archiver ton swap ?????
T'es malade ou quoi ?
23:46 23:41 Pfff t'as jamais travailler dans une vrai entreprise ou
quoi ???? La loi elle oblige à tout backuper et archiver !!!!