Rechercher une page de manuel

Chercher une autre page de manuel:


Langue: en

Version: 14 Sep 2000 (debian - 07/07/09)

Section: 1 (Commandes utilisateur)


bump - send signal to tags run by pan


bump [-1] [-s sig] [-a active-file] [tags...]  


Bump will send a SIGINT signal to processes, given that each process has a corresponding tag in an active-file. The active-file is the same one that is used by the pan to start the processes.

If the active file has multiple occurrences of a single tag name then only the first process will be signaled. You may specify the tag name multiple times on the commandline if necessary.

Send a SIGUSR1 signal. By default a SIGINT will be sent.
-a active_file
A file containing the tagnames, pids, and commands being run by a pan. If this is not specified then the ZOO environment variable will be read for the name of the directory where the active file can be found.
-s sig
Used to specify a signal number to send. By default a SIGINT will be sent.


If set, should name the directory where the active file can be found. This is ignored if -a is specified.


Default name of active file if -a is not specified. This is prefixed by the directory name found in the ZOO environment variable.


Zoo tools - pan(1ltp)


Exits zero, unless it cannot find the active file or if there were no tags listed on the commandline.
> Ceci est le Premier Appel A Discussion [blabla]
Dites le que cet AAD est un truc pour tester ReiserFS ou tout
autre FS pour Nunusque susceptible d'acceuillir un active de plus de 2GO ?
-+- AT in Guide du Fmblien Assassin : "De l'utilité des AAD fcol..." -+-