detok

Langue: en

Version: May 15, 2007 (debian - 07/07/09)

Section: 1 (Commandes utilisateur)

NAME

detok - OpenBIOS detokenizer

SYNOPSIS

detok [options] forth-file

DESCRIPTION

detok is an open-source FCode detokenizer for the OpenBIOS project. It performs the reverse function, that is, it converts binary FCode into a form that can be read for purposes of verification.

OPTIONS

-h, -?
Print a brief help message and then exit.
-v, --verbose
Print additional messages: the hex value of each token processed, as well as a signature block.
-o
Display the positions of the tokens relative to the start of the first FCode block after a PCI header (if one is present), and the destination-offset of each branch.
Note that the combination of the Verbose and Offsets options yields the maximum amount of useful information.
-n
Display the sequential number of each line of output.
Note that the -n and -o options are mutually exclusive; if both are specified, -o will be favoured.
-a
Do not stop when end0 has been encountered. This option is usually not needed, but may be useful in cases where a file has been corrupted or when something very strange has been tokenized...
-f FCode-List-File
Pre-load additional FCodes before processing. These might be, for instance, a set of vendor-specific FCodes that were generated for a specific vendor's products by a tokenizer customized for that specific vendor.

SEE ALSO

toke(1).

AUTHORS

David L. Paktor <dlpaktor@us.ibm.com>

This manual page was written by Aurelien Jarno <aurel32@debian.org> for the Debian GNU/Linux system (but may be used by others).