Rechercher une page de manuel

Chercher une autre page de manuel:


Langue: en

Autres versions - même langue

Version: 258685 (debian - 07/07/09)

Section: 1 (Commandes utilisateur)


openipmish - Shell interface to an IPMI system


openipmish [option]


The openipmish is a command interpreter that gives the full power of the OpenIPMI library to a user-level command language. It is designed so it can easily be driven with a scripting language like TCL, it has well-formed output.

openipmish starts up with no connections or anything of that nature. You must enter commands to make connections to domains.


Turn on message debugging, this will dump all messages to debug log output.
Turn on raw message debugging, this will dump all low-level messages to debug log output. This differes from normal message debugging in that all protocol messages are also dumped, not just IPMI messages.
Turn on memory debugging, this will cause memory allocation and deallocations to be checked. When the program terminates, it will dump all memory that was not properly freed (leaked).
Turn on lock debugging, this will check lock operations to make sure that locks are help in all the proper places and make sure that locks are properly nested.
Enable the SNMP trap handler. openipmish must be compiled with SNMP code enabled for this option to be available.
Help output


openipmish follows the standard command syntax defined in ipmi_cmdlang(7). See that for the details on most commands. The IPMI manual that comes with OpenIPMI will also be quite handy.

openipmish defines some commands that are not in the standard command language. These are:

Read and execute commands from the given file.
redisp_cmd on|off
Normally, openipmish redisplays the command line when an event comes in. This is nice for interactive use, but bad for scripting. This lets you turn that function on and off.


ipmi_cmdlang(7), ipmi_ui(1)




Corey Minyard <>

Le silence est le plus beau bijou d'une femme, mais elle le porte
-+- Proverbe Anglais -+-