Rechercher une page de manuel
state
Langue: en
Version: 179487 (CentOS - 06/07/09)
Section: 1 (Commandes utilisateur)
NAME
state - Report status of LAM processes.SYNTAX
state [-ghklt] <nodes> [<processes>]OPTIONS
- -g
- Print information on system and application processes.
- -h
- Print the command help menu.
- -k
- Only obtain kernel information on local kernel processes.
- -l
- Print supplementary information.
- -t
- Print information on system processes only.
DESCRIPTION
Most MPI users will probably not need to use the state command; see mpimsg(1) and mpitask(1). This command is only installed if LAM/MPI was configured with the --with-trillium switch.If no process selection is given on the command line, one line of status will be printed for every process on each specified node.
In default mode, information is organized under the following headings:
- NODE
- the nodeid on which the process is running
- INDEX
- the LAM process index
- PID
- the process identifier from the underlying operating system
- KPRI
- the LAM kernel priority
- KSTATE
- the LAM kernel execution status:
-
- R
- running - unencumbered by LAM
- BR
- blocked receiving - The blocked message event and type are also displayed.
- BS
- blocked sending - The blocked message event and type are also displayed.
- F
- no longer a LAM process
-
- PROGRAM
- the program filename
With the -l option, state prints signal information instead of execution status.
- SIGS
- all pending but undelivered LAM signals
Some event/type combinations are used by the system to implement client/server requests or to implement other message passing libraries. Where possible, state replaces these numbers with the name of the function that caused the current execution state. In general, the information provided by state is low-level and geared toward LAM system programmers. MPI programmers are expected to use mpitask(1) to monitor the state of MPI processes.
Kernel Processes
A process must call kenter(2) or be created by loadgo(1) in order to be directly visible to state. In other cases, limited monitoring is possible in one of two ways. If a process identifier is given, the kernel on each specified node will be consulted for kernel information (kstate(2)). On the local node (use node specifier h) a process can be watched without the assistance of the process management daemon by giving the process identifier and the -k option.EXAMPLES
- state n0-7
- Display the status of all application processes on nodes 0 through 7.
- state n7 i4
- Display the status of LAM process index 4 on node 7.
DIAGNOSTICS
If no processes are found, only the title line is displayed.SEE ALSO
loadgo(1), mpimsg(1), mpitask(1), doom(1), bfstate(1)Contenus ©2006-2024 Benjamin Poulain
Design ©2006-2024 Maxime Vantorre