Rechercher une page de manuel
yac2ncid
Langue: en
Version: 370346 (fedora - 01/12/10)
Section: 1 (Commandes utilisateur)
NAME
yac2ncid - YAC server to NCID server gatewaySYNOPSIS
yac2ncid [-v]DESCRIPTION
YAC2NCID acts as a YAC client, listens to the CID information from a YAC server and sends it to the NCID server. The server then sends the CID information to the NCID clients.It is important to understand that to run YAC server with NCID clients you must run YAC2NCID gateway as well as NCID server.
The configuration file for ncid is /etc/ncid/ncid.conf. It may be located in same directory as the script, or in the etc directory, or in NCID default configuration directory. Read the comments in the config file for more details.
YAC2NCID can run on any system, but normally it is run on same box as the NCID server. If it is not run on the same box as the NCID server, you must configure the server IP address in the configuration file.
Configure the YAC server with IP address of the box running YAC2NCID.
YAC2NCID relies on netcat binary (nc). As there are multiple implementations of this binary in existence, the script will try to autodetect the options to use. If script is unable to properly detect the version of nc, set NETCAT_TYPE to CUSTOM in the config file and set custom params to match your version.
There is also a client output module called ncid-yac. It sends the NCID CID information to YAC clients.
OPTIONS
- -v
- Verbose mode.
REQUIRED PROGRAMS
netcat: /usr/bin/ncFILES
/etc/ncid/yac2ncid.confSEE ALSO
yac2ncid.conf.5, ncidd.8, ncidd.conf.5, ncidd.alias.5, ncidmodules.1Contenus ©2006-2024 Benjamin Poulain
Design ©2006-2024 Maxime Vantorre