Rechercher une page de manuel

Chercher une autre page de manuel:


Langue: en

Version: 361783 (ubuntu - 24/10/10)

Section: 4 (Pilotes et protocoles réseau)

BSD mandoc


urtw - Realtek RTL8187B/L USB IEEE 802.11b/g wireless network device


To compile this driver into the kernel, place the following lines in your kernel configuration file:
device ehci device uhci device ohci device usb device urtw device wlan

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:



The driver supports USB 802.11b/g wireless adapters based on the Realtek RTL8187B/L.

supports station and monitor mode operation. Only one virtual interface may be configured at any time. For more information on configuring this device, see ifconfig(8).


The driver supports Realtek RTL8187B/L based wireless network devices, including:
Card  Radio   Bus
"Netgear WG111v2        RTL8225 USB"
"Safehome WLG-1500SMA5    RTL8225 USB"
"Shuttle XPC Accessory PN20RTL8225USB"


Join an existing BSS network (i.e., connect to an access point):
 ifconfig wlan create wlandev urtw0 inet \
     netmask 0xffffff00

Join a specific BSS network with network name ``my_net ''

"ifconfig wlan create wlandev urtw0 ssid my_net up"

Join a specific BSS network with 64-bit WEP encryption:

 ifconfig wlan create wlandev urtw0 ssid my_net \
         wepmode on wepkey 0x1234567890 weptxkey 1 up


intro(4), netintro(4), usb(4), wlan(4), wlan_ccmp4, wlan_tkip4, wlan_wep4, ifconfig(8), wpa_supplicant8


The device driver first appeared in Fx 8.0 .


An -nosplit The driver was written by An Weongyo Jeong Aq .
18:38 Pour recompiler un noyau le bzImage est il obligatoire??
18:39 18:39 non, tu copies un tarball des sources dans /boot, et tu
l'installes dans lilo
18:40 18:39 et l'ancien je le vire??
18:41 18:40 je te conseille pas, non
18:42 18:41 OK ,je v essayer