Rechercher une page de manuel
astribank_hexload
Langue: en
Version: 306073 (debian - 07/07/09)
Section: 8 (Commandes administrateur)
NAME
astribank_tool - Xorcom Astribank (xpp) firmware loaderSYNOPSIS
astribank_tool -D device-path <-F|-p> [options] hexfileastribank_tool [-h]
DESCRIPTION
astribank_hexload is a second-stage firmware loader for Xorcom Astribanks. Note that some older models use fpga_load(8) instead.It is used to load a file in the Intel HEX format into a Xorcom Astribank. It can be used to load either an FPGA firmware or a PIC firmware. It is normally run by the script xpp_fxloader.
OPTIONS
-D device-path- Required. The device to read from/write to. On modern UDEV-based system this is usually /dev/bus/usb/bus_num/device_num, where bus_num and device_num are the first two numbers in the output of lsusb(8). On older systems that use usbfs, it is usually /proc/bus/usb/bus_num/device_num.
-F
- The firmware to load is a FPGA firmware.
-p
- The firmware to load is a PIC firmware.
-v
- Increase verbosity. May be used multiple times.
-d mask
- Set debug mask to mask. Default is 0, 0xFF is "everything".
-h
- Displays usage message.
SEE ALSO
fxload(8), lsusb(8), astribank_tool(8), fpga_load(8)AUTHOR
This manual page was written by Tzafrir Cohen <tzafrir.cohen@xorcom.com> . Permission is granted to copy, distribute and/or modify this document under the terms of the GNU General Public License, Version 2 any later version published by the Free Software Foundation.On Debian systems, the complete text of the GNU General Public License can be found in /usr/share/common-licenses/GPL.
Contenus ©2006-2024 Benjamin Poulain
Design ©2006-2024 Maxime Vantorre