Rechercher une page de manuel
athdebug
Langue: en
Version: 328650 (ubuntu - 08/07/09)
Section: 8 (Commandes administrateur)
NAME
athdebug - control the debug output from the madwifi device subsystemSYNOPSIS
athdebug [-i device] +/- bitmapDESCRIPTION
Set and clear debug bitmaps for the madwifi ath device subsystem. Each argument is a bitmap or its alias. If a bitmap alias is used then it must be prefixed by either "-" to clear or "+" to set the corresponding bitmap.All debugging output can be enabled with the 0xffffffff bitmap, while 0x0 disables all debug output.
OPTIONS
- -?
- Display usage and list all debug flags.
- -i device
- The madwifi device to apply the settings to. If no interface is specified, athdebug defaults to wifi0.
- +/- bitmap
- Set (+) or clear (-) a debug flag.
BITMAP ALIASES
xmit - transmit of packets, just before they go out to the HWxmit_desc - transmit descriptors
recv - received packets, directly from the HW
recv_desc - recv descriptors
rate - rate control modules
reset - reset processing and inititalization
mode - mode initialization and changes
beacon - beacon handling
watchdog - watchdog timeout
intr - interrupt processing
xmit_proc - processing of transmit descriptors
recv_proc - processing of receive descriptors
beacon_proc - beacon processing
calibrate - periodic re-calibration
keycache - key cache management
state - 802.11 state transitions
node - node management ff - fast frame handling
fatal fatal errors
EXAMPLES
- athdebug -i wifi1 0xffffffff
- Enable all debug bitmaps on wifi1.
- athdebug +rate
- Enable rate debug bitmap on wifi0.
- athdebug -rate
- Clear rate bitmap on wifi0.
SEE ALSO
80211debug(8), http://madwifi.org/wiki/DevDocs/AthDebugAUTHOR
This manual page was written by Kel Modderman <kelrin@tpg.com.au> and was based upon previous text written by Eric S. Raymond.Contenus ©2006-2024 Benjamin Poulain
Design ©2006-2024 Maxime Vantorre