Rechercher une page de manuel
hp100vg-diag
Langue: en
Version: October 22, 2003 (ubuntu - 08/07/09)
Section: 8 (Commandes administrateur)
NAME
hp+-diag - Diagnostic program for HP 100VG vetwork adaptorsSYNOPSIS
hp+-diag [options]DESCRIPTION
hp100vg-diag is a diagnostic program for the HP 100VG Ethernet adapter using the Lucent ATT2MD01 chips. You can use this program to diagnose problems with your enternet adapters.OPTIONS
These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.- -h, --help
- Show summary of options.
- -V, --version
- Show version of program.
- -v, --verbose
- Verbose mode.
- -D, --debug
- Debug mode.
- -a, --show_all_registers
- Print all registers.
- -e, --show-eeprom
- Dump EEPROM contents,
- -m, --show_mii
- Print the MII transceiver state Using -mm monitors the link.
- -f, --force
- Perform operation, even on a running NIC.
- -p, --port-base <port>
- Specify port to use. Valid values are: 0x240, 0x280, 0x300, 0x320, 0x340, 0x360
- -#, --card_num <number>
- Operate on the specified card index.
- -t, --chip-type <type> Specify adapter type with '-p', use '-1' to list.
- -G, --parameters <parms>
- Write adapter-specific parameters in the persistent EEPROM settings.
- -H, --new-hwaddr 01:23:45:67:ab:cd
- Set a new hardware station address. Typically diabled.
- -B
- Show the first few bytes of the ROM
- -L <file>
- Load the Flash from FILE.
- -S <file>
- Store the Flash image to FILE.
- -w, --write-EEPROM <values>
- Write to the EEPROMS with the specified values.
SEE ALSO
mii-diag(8)AUTHOR
This manual page was written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others).Contenus ©2006-2024 Benjamin Poulain
Design ©2006-2024 Maxime Vantorre