Rechercher une page de manuel
oneac
Langue: en
Version: 66251 (mandriva - 22/10/07)
Section: 8 (Commandes administrateur)
Sommaire
NAME
oneac - Driver for Oneac UPS equipmentNOTE
This man page only documents the hardware-specific features of the oneac driver. For information about the core driver, see nutupsdrv(8).SUPPORTED HARDWARE
This driver supports Oneac EG and ON UPS equipment with the Advanced Interface. If your UPS is equipped with the Basic Interface card, use the genericups driver.EXTRA ARGUMENTS
This driver supports the following optional settings in the ups.conf(5):- testtime=num
- Change battery test time from the 2 minute default.
INSTANT COMMANDS
This driver supports the following Instant Commands.- reset.input.minmax
- Reset the minimum and maximum input line voltage values seen since the last reset or power on.
- test.battery.start
- Start a battery test. The default time is 2 minutes. This time can be set in the ups.conf file. See testime above.
- test.battery.stop
- Stops a battery test that is in progress.
- test.failure.start
- Starts a 15 second long simulation of an input power failure.
AUTHOR
Eric Lawson <elawson@inficad.com>SEE ALSO
The core driver:
nutupsdrv(8)Internet resources:
The NUT (Network UPS Tools) home page: http://www.networkupstools.org/Contenus ©2006-2024 Benjamin Poulain
Design ©2006-2024 Maxime Vantorre