Rechercher une page de manuel
sg_rtpg
Langue: en
Version: 51980 (openSuse - 09/10/07)
Section: 8 (Commandes administrateur)
NAME
sg_rtpg - sends a SCSI REPORT TARGET PORT GROUPS commandSYNOPSIS
sg_rtpg [--decode] [--help] [--hex] [--raw] [--verbose] [--version] DEVICEDESCRIPTION
Send a SCSI REPORT TARGET PORT GROUPS command to DEVICE and outputs the response.
Target port group access is described in SPC-3 found at www.t10.org in section 5.8 (in rev 21c dated 2005/1/15). The Report Target Port Groups command is also described in that document.
OPTIONS
Arguments to long options are mandatory for short options as well.- -d, --decode
- decodes the status code and asymmetric access state from each target port group descriptor returned. The default action is not to decode these values.
- -h, --help
- output the usage message then exit.
- -H, --hex
- output response in hex (rather than partially or fully decode it).
- -r, --raw
- output response in binary to stdout.
- -v, --verbose
- increase the level of verbosity, (i.e. debug output).
- -V, --version
- print the version string and then exit.
NOTES
The Report Target Port Groups command should be supported whenever the TPGS bits in a standard INQUIRY response are greater than zero. [View with sg_inq utility.]EXIT STATUS
The exit status of sg_rtpg is 0 when it is successful. Otherwise see the sg3_utils(8) man page.AUTHORS
Written by Douglas Gilbert.REPORTING BUGS
Report bugs to <dgilbert at interlog dot com>.COPYRIGHT
Copyright © 2004-2007 Christophe Varoqui and Douglas GilbertThis software is distributed under a FreeBSD license. There is NO warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.
SEE ALSO
sg_inq(sg3_utils)Contenus ©2006-2024 Benjamin Poulain
Design ©2006-2024 Maxime Vantorre