Rechercher une page de manuel
tulip-diag
Langue: en
Version: 304297 (debian - 07/07/09)
Section: 8 (Commandes administrateur)
NAME
tulip-diag - EEPROM setup and diagnostic program for ethernet cards based on the Digital DC21x4* chip.SYNOPSIS
tulip-diag [options]DESCRIPTION
tulip-diag is a program that you can use to diagnose problems with ethernet cards based on Digital DC21x4* chips. This includes the following chips: Digital and Intel 21040/041/140/142/143/145 and others from Lite-On, LinkSys, Macronix, ASIX, Compex, STmicro, ADMtek, Davicom and Xircom.OPTIONS
These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.- -h, --help
- Show summary of options.
- -V, --version
- Show version of program.
- -v, --verbose
- Verbose mode.
- -q, --quiet
- Be very unverbose.
- -# <cardnum>
- Use card number <cardnum>.
- -a, --show_all_registers
- Print all registers.
- -e, --show-eeprom
- Dump EEPROM contents to stdout.
- -E, --emergency-rewrite
- Re-write a corrupted EEPROM.
- -p, --base-address <port>
- Specify port to use.
- -A, --Advertise <mediaype>
- Advertise media type. Valid Options are: 10baseT, 100baseT4, 100baseTx, 100baseTx-FD, 100baseTx-HD, 10baseT-FD and 10baseHD.
- -F, --new-interface <interface>
- Interface number. Options that make sense are: 10baseT, 10base2, AUI, 100baseTx, 10baseT-FDX, 100baseTx-FDX, 100baseT4, 100baseFx, 100baseFx-FDX, MII, HomePNA and Autosense.
- -H, --new-hwaddress <address>
- Set card to a new hardware address.
- -m, --show-mii
- Dump MII management registers.
- -R, --reset
- Reset the transceiver.
- -T, --test
- Do register and SRAM test.
- -w, --write-EEPROM <values>
- Write to the EEPROMS with the specified values. Do not use this, if you do not know what you do!
- -f, --force-detection
- Try to identify the card, even if it is active.
- -t, --chip-type <card>
- Explicitly set the chip. To get all valid numbers, run tulip-diag with the options '-t -1'.
SEE ALSO
mii-diag(8)AUTHOR
tulip-diag was written and is still maintained by Donald Becker <becker@scyld.com>. This manual page was written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others).Contenus ©2006-2024 Benjamin Poulain
Design ©2006-2024 Maxime Vantorre