Rechercher une page de manuel
wackatrl
Langue: en
Version: Arpirl 2004 (debian - 07/07/09)
Section: 8 (Commandes administrateur)
NAME
wackatrl - IP-failover high-availability controllerSYNOPSIS
wackatrl [-c config_file ] [ -l | -f | -s ]DESCRIPTION
wackatrl runs the wackatrl IP-failover HA controller and instructs the currently running Wackamole instance to perform an action or display state information.OPTIONS
- -c config-file
- Use an alternate configuration file config-file instead of wackamole.conf.
- -l
- Lists the current state (ownership) of virtual interfaces.
- -f
- Simulate a failure. The local instance will disconnect from Spread and act as if it has failed by dropping its managed interfaces and running whatever dynamic calls have been configured. A peer, should one exist, will assume the responsibility for the interfaces that were dropped.
- -s
- Recover from a simulated failure. This will tell the local instance to stop simulating failure. The local instance will reconnect to Spread and once again participate in the peer-based HA environment.
FILES
wackamole.conf- The default config file location is dependant on the install prefix. ./wackamole.conf is also searched if a local file is not found.
DIAGNOSTICS
All error messages, should any be produced will be written to standard error.BUGS
No known bugs.AUTHOR
Theo Schlossnagle <jesus@cnds.jhu.edu>SEE ALSO
wackamole(8),wackamole.conf(5)Contenus ©2006-2024 Benjamin Poulain
Design ©2006-2024 Maxime Vantorre