struct_regulator_ops

Langue: en

Autres versions - même langue

Version: October 2010 (fedora - 01/12/10)

Section: 9 (Appels noyau Linux)

NAME

struct_regulator_ops - regulator operations.

SYNOPSIS

 struct regulator_ops {
   int (* list_voltage) (struct regulator_dev *, unsigned selector);
   int (* set_voltage) (struct regulator_dev *, int min_uV, int max_uV);
   int (* get_voltage) (struct regulator_dev *);
   int (* set_current_limit) (struct regulator_dev *,int min_uA, int max_uA);
   int (* get_current_limit) (struct regulator_dev *);
   int (* enable) (struct regulator_dev *);
   int (* disable) (struct regulator_dev *);
   int (* is_enabled) (struct regulator_dev *);
   int (* set_mode) (struct regulator_dev *, unsigned int mode);
   unsigned int (* get_mode) (struct regulator_dev *);
   int (* enable_time) (struct regulator_dev *);
   int (* get_status) (struct regulator_dev *);
   unsigned int (* get_optimum_mode) (struct regulator_dev *, int input_uV,int output_uV, int load_uA);
   int (* set_suspend_voltage) (struct regulator_dev *, int uV);
   int (* set_suspend_enable) (struct regulator_dev *);
   int (* set_suspend_disable) (struct regulator_dev *);
   int (* set_suspend_mode) (struct regulator_dev *, unsigned int mode);
 };  
 

MEMBERS

list_voltage

Return one of the supported voltages, in microvolts; zero if the selector indicates a voltage that is unusable on this system; or negative errno. Selectors range from zero to one less than regulator_desc.n_voltages. Voltages may be reported in any order.

set_voltage

Set the voltage for the regulator within the range specified. The driver should select the voltage closest to min_uV.

get_voltage

Return the currently configured voltage for the regulator.

set_current_limit

Configure a limit for a current-limited regulator.

get_current_limit

Get the configured limit for a current-limited regulator.

enable

Configure the regulator as enabled.

disable

Configure the regulator as disabled.

is_enabled

Return 1 if the regulator is enabled, 0 if not. May also return negative errno.

set_mode

Set the configured operating mode for the regulator.

get_mode

Get the configured operating mode for the regulator.

enable_time

Time taken for the regulator voltage output voltage to stabalise after being enabled, in microseconds.

get_status

Return actual (not as-configured) status of regulator, as a REGULATOR_STATUS value (or negative errno)

get_optimum_mode

Get the most efficient operating mode for the regulator when running with the specified parameters.

set_suspend_voltage

Set the voltage for the regulator when the system is suspended.

set_suspend_enable

Mark the regulator as enabled when the system is suspended.

set_suspend_disable

Mark the regulator as disabled when the system is suspended.

set_suspend_mode

Set the operating mode for the regulator when the system is suspended.

DESCRIPTION

This struct describes regulator operations which can be implemented by regulator chip drivers.

AUTHORS

Liam Girdwood <lrg@slimlogic.co.uk>

Author.

Mark Brown <broonie@opensource.wolfsonmicro.com>
Wolfson Microelectronics,
      
     

Author.